[T3] T3 Front end bushings

[Dave Hall]

Yes, several mm thick and as big as it could be to get through the old bush.
I suspect it's shown in use in the Factory Workshop manual - I can't find it
in the Bentley, but I've seen it somewhere too, along with a stepped driver
to fit the bush at the right depth.

I've also got tools for local manufacture and a VW tools catalogue, but
they're a bit buried at the moment.

Dave.
UK VW Type 3&4 Club
===================

-----Original Message-----
From: type3-vwtype3.org-bounces at lists.vwtype3.org
[mailto:type3-vwtype3.org-bounces at lists.vwtype3.org] On Behalf Of Jim Adney
Sent: 23 December 2012 02:39
To: type3 at vwtype3.org
Subject: Re: [T3] T3 Front end bushings

On 23 Dec 2012 at 0:47, Dave Hall wrote:

> The tool VW used was an oval washer on the slide hammer end, that went 
> in and seated behind the bush.

That was a pretty fancy "oval washer" wasn't it? Isn't there a photo of it
in the Bentley? Or am I remembering one of the tool catalogs?

--
*******************************
Jim Adney, jadney at vwtype3.org
Madison, Wisconsin, USA
*******************************

_______________________________________________
VWType3.Org mailing list - type3 at vwtype3.org
http://lists.vwtype3.org/listinfo.cgi/type3-vwtype3.org
Contact gregm at vwtype3.org if you need help with the list.