[T3] T3 Front end bushings
Keith Park
topnotch at nycap.rr.com
Sat Dec 22 20:27:23 PST 2012
IT wasn't an oval, it was a washer with 2 sides filed in it and an elongated
hole so the washer could slide thru the bushing and grab when brought
perpendicular on the other side. Russ has these, I remember looking at them
in his toolkit. I THINK I took a picture of them, but that would have been
10 years ago and I wasn't digital yet, so Id have to dig it out.
I wonder where those tools wound up?
Keith
Top Notch Restorations
topnotch at nycap.rr.com
http://www.a383ina68.addr.com/radiorest/main.htm
71 Squareback "Hothe"
65 Notchback "El Baja Rojo"
65 Squareback "Eggcrate"
87 golf "Winterat"
93 RX7 "Redstur"
-----Original Message-----
From: type3-vwtype3.org-bounces at lists.vwtype3.org
[mailto:type3-vwtype3.org-bounces at lists.vwtype3.org] On Behalf Of Jim Adney
Sent: Saturday, December 22, 2012 9:39 PM
To: type3 at vwtype3.org
Subject: Re: [T3] T3 Front end bushings
On 23 Dec 2012 at 0:47, Dave Hall wrote:
> The tool VW used was an oval washer on the slide hammer end, that went in
> and seated behind the bush.
That was a pretty fancy "oval washer" wasn't it? Isn't there a photo
of it in the Bentley? Or am I remembering one of the tool catalogs?
--
*******************************
Jim Adney, jadney at vwtype3.org
Madison, Wisconsin, USA
*******************************
_______________________________________________
VWType3.Org mailing list - type3 at vwtype3.org
http://lists.vwtype3.org/listinfo.cgi/type3-vwtype3.org
Contact gregm at vwtype3.org if you need help with the list.
More information about the type3-vwtype3.org
mailing list