[T3] Window rubber
Bobsnotch at aol.com
Bobsnotch at aol.com
Sun Jul 15 05:57:50 PDT 2012
In a message dated 7/15/2012 1:23:04 A.M. Eastern Daylight Time,
jimmyandcher at yahoo.com writes:
OK, thanks for the info. At this point my inside scrapers are still
good. I just need the passenger side outer scraper replaced.
Jimmy
On Jul 14, 2012, at 9:48 PM, Brent Bottolfson wrote:
> I used Bus scrapers for the inners and 68+ Beetles for the outers.
> I used Bob's method of attaching them with a rivet without the 'nail'.
>
> You can get real VW brand Beetle scrapers from Wolfsburg West and
> very good quality Bus repops for the inners. Mine turned out
> really nice and lay flat.
>
> -Brent
>
> On 7/14/12 11:21 PM, James Lingenfelter wrote:
>> So, is it generally agreed that the bay window bus inner scrapers
>> make a better substitute than the late beetle outer scrapers? Just
>> trying to figure out exactly what I should get.
>>
>> On Jul 14, 2012, at 5:30 PM, Keith Park wrote:
>>
>>> I used the T2 rubber, I think it was the inners for the Outers on
>>> the T3
>>> trim. The flange isn't really deep but it was deep enough to
>>> punch holes in
>>> and rivet them inside the sandwich between the aluminum trim and
>>> the inner
>>> steel clamp. The one thing I do remember is to make sure you get
>>> them down
>>> far enough before you punch the holes, you want the lip on the
>>> scraper to go
>>> right against the aluminum trim to kind of kick it in toward the
>>> window just
>>> a bit.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.vwtype3.org/private.cgi/type3-vwtype3.org/attachments/20120715/b38a550c/attachment.htm>
More information about the type3-vwtype3.org
mailing list