[T3] Heater hose
Jim Adney
jadney at vwtype3.org
Tue Nov 20 22:05:12 PST 2012
On 20 Nov 2012 at 15:06, Bobsnotch at aol.com wrote:
> Yes, the reason is length. On the 64 and very early 65's, the heater valve
> was located on the body, while after Oct 64 (65 MY), the valve was built
> into the heat exchanger. Prior to Nov 63, the earlier tubing was 55 mm. I
> know all about this, as I went thru it when I replaced that section under the
> rear seat on my 64 T-34. That car got a section from a 62 T-34, that used
> the earlier smaller diameter tubes.
Might the Type 34s have been different? There are no smaller dia
hoses listed in the Type 3 microfilm.
I expected that changing the location of the air valves would have
changed the lengths on both sides, or neither side, but for some
reason it seems to have changed the length on only one side. I remain
puzzled.
--
*******************************
Jim Adney, jadney at vwtype3.org
Madison, Wisconsin, USA
*******************************
More information about the type3-vwtype3.org
mailing list