[T3] Front axle beam question
Keith Park
topnotch at nycap.rr.com
Fri Oct 3 19:46:45 PDT 2014
OK, I grabbed the seal again and the depth gauge,
.404" from the collar to the end of the shank.
KEith
Topnotch Restorations
topnotch at nycap.rr.om
http://www.a383ina68.addr.com/radiorest/main.htm
71 Squareback "Hothe"
65 Squareback "Eggcrate"
65 Notchback "El Baja Rojo"
93 RX7 "Redstur"
87 Golf "Winterat"
-----Original Message-----
From: type3-vwtype3.org [mailto:type3-vwtype3.org-bounces at lists.vwtype3.org]
On Behalf Of Jim Adney
Sent: Wednesday, October 01, 2014 9:08 PM
To: type3 at vwtype3.org
Subject: Re: [T3] Front axle beam question
On 1 Oct 2014 at 20:15, Keith Park wrote:
> I must not be understanding this, there is a spec for how far the bearings
> go in if I recall right, then you just pop the seal in as far as it goes
and
> walla, your done.
You're right, there is a stated spec for the bearing position, and
there is a depth of the seal, but those two dimensions allow for some
overlap, which is impossible. So the stated spec must be wrong.
The question is: What is the correct spec? There's no stop.
--
*******************************
Jim Adney, jadney at vwtype3.org
Madison, Wisconsin, USA
*******************************
_______________________________________________
VWType3.Org mailing list - type3 at vwtype3.org
To unsubscribe or change subscription options, visit:
http://lists.vwtype3.org/listinfo.cgi/type3-vwtype3.org
If you need more help, contact: gregm at vwtype3.org
More information about the type3-vwtype3.org
mailing list