[T3] N.O.S. Mufflers with loose upper heat exchangers
Bobsnotch at aol.com
Bobsnotch at aol.com
Wed Nov 11 06:49:58 PST 2015
In a message dated 11/11/2015 1:13:29 A.M. Eastern Standard Time,
jadney at VWType3.org writes:
> *Further, the copper rings are N.L.A. separate and good luck finding a
muffler kit. Even the O.E.M.kit needed a good bit of exhaust paste.
You can make suitable subs for the copper seals by cutting up the
diamond-shaped exhaust port gaskets. I stock complete muffler
installation kits.
Russ recommended using thermocouples (old or new) with the ends cut on a
taper to fit and squish into each other. According to him, a hot water heater
thermocouple is plenty long enough to do 1 muffler. Just a reminder for
those looking for a cheaper/easier to find solution. ;-)
Bob 65 Notch with sunroof
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.vwtype3.org/pipermail/type3-vwtype3.org/attachments/20151111/b42a1e1f/attachment.htm>
More information about the type3-vwtype3.org
mailing list