[T3] type3-vwtype3.org Digest, Vol 79, Issue 6

Dave Hall dave at hallvw.clara.co.uk
Sun Apr 9 17:13:32 PDT 2017


The +12V on the coil is the power source, via an inline 8-amp fuse to the
transmission switch, and from the other connection on the switch to the
reversing bulbs. Make sure the wires are sheathed to stop shorts as they go
through the body holes, and use grommets.  The holders should be earthed
through the light units, but check there is a good connection - I think
there should be a brown wire from a screw on the inner fender by the light
units (each side) to earth tags on the light units.

Dave
UK VW Type 3&4 Club
===================

-----Original Message-----
From: type3-vwtype3.org [mailto:type3-vwtype3.org-bounces at lists.vwtype3.org]
On Behalf Of B Fye
Sent: 09 April 2017 23:15
To: type3-vwtype3.org at lists.vwtype3.org
Subject: Re: [T3] type3-vwtype3.org Digest, Vol 79, Issue 6

***********************************
When replying, please consider trimming your message. Thanks! :)
***********************************

Well, since I have the switch on the trans and bulbs in the holders, where
do I need to run wires to and from?


--
Brian
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://lists.vwtype3.org/pipermail/type3-vwtype3.org/attachments/20170409/d
b9f08d0/attachment.htm>
_______________________________________________
VWType3.Org mailing list - type3 at vwtype3.org To unsubscribe or change
subscription options, visit:
http://lists.vwtype3.org/listinfo.cgi/type3-vwtype3.org
If you need more help, contact: gregm at vwtype3.org


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus



More information about the type3-vwtype3.org mailing list