[T3] gas mileage, voltage, etc.
Gary Forsmo
gbforsmo at gmail.com
Wed Jun 28 10:37:17 PDT 2017
Jim wrote:
>It's possible that you didn't squeeze the connectors
>hard enough. They are small and stiff, so it takes a bit of pressure
>to have an effect. Unfortunately, there's a fine line between enough
>pressure and too much pressure. That's why you have to check each
>female pin on a male pin before you put them back into the connector
>body.
Would it be possible to build a small "tool" of metal, like the male pin
(width & thickness) as a "Go/No Go" checker?
By using this "tool" you may be able, and handier, to adjust the female
pins and FEEL whether they are:
1. too tight,
2. too loose, or
3. just about the correct amount of tension as the male pin is slipped
in and out of the female connector.
--
Gary "Frito" - '69 Squareback, FI, MT, One-owner
Rockport, TX (winter)
Lake Geneva, WI (summer)
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.vwtype3.org/pipermail/type3-vwtype3.org/attachments/20170628/1dcf138c/attachment.htm>
More information about the type3-vwtype3.org
mailing list