[T3] notch seat back anchor points
Jim Adney
jadney at vwtype3.org
Fri Aug 3 06:27:54 PDT 2018
On 2 Aug 2018 at 19:51, Gary Forsmo wrote:
> Should I have the "plater" strip the paint and ask him to use standard
> zinc plating over the steel?
I think it would be hard to replate that assembly, just because there are lots
of tight spots in there that would hold solution and not plate well, and the
moving parts might not work afterwards. In general, platers also like to
immerse parts to be plated completely, rather than dip them in and just plate
part of the item, because the surface of the tank tends to leave a rather large
crusty edge to the plating.
You might be able to get away with the crusty edge if there's an inch or so of
straight section that would be covered by the black plastic.
Your best bet would be to find an OE part that was still in good condition.
They were used on all Type 3s from '68 to '71 and maybe early '72. Beetles
may have gotten the same part in the same years.
--
*******************************
Jim Adney, jadney at vwtype3.org
Madison, Wisconsin, USA
*******************************
More information about the type3-vwtype3.org
mailing list