[T3] Valve Cover
Jim Adney
jadney at vwtype3.org
Thu Aug 16 08:08:58 PDT 2018
On 15 Aug 2018 at 19:25, Jeff C wrote:
> What is the current way to ensure the valve covers are sealed?
I use a small dab of sealer in the middle of each long side, between the
gasket and the cover. That keeps the long side of the gasket from "drooping"
inward. If the gasket you use is the right size, that's all you need. NEVER
glue the gasket to the head!
Late valve covers have a little dimple pushed inward on the top to prevent
that "droop" on the top, but I've seen gaskets creep upward along the
bottom.
Berg recommends keeping a spare set of covers on a spare set of heads, so
the sealant will be dried/set when you need them. I've never done this, but it
sounds reasonable because wet sealant could still allow slippage.
On the head side of the gasket, I run my finger along the full length of the
mating surface of the head, to make sure it's smooth. Then I wet that finger
in some old oil from the head or cover and wet both the mating surface of the
head and the head side of the gasket.
I find that the gaskets last thru many valve adjustments. I replace them only
if I can no longer push a fingernail into them. There seem to be 2 common
types of gaskets: black or beige. The black ones are good, but the beige
ones, that seem to come in the gasket sets, are undersize and don't fill the
cavity in the cover. I understand that they can be expanded by a minute or
so in boiling water in a small frying pan, but I've never done that. (I
remember seeing mechanics doing this in the 60s at my dealership. There
was a hotplate on one side of the shop that everyone used. I didn't
understand what they were doing until Russ explained it.)
Don't ever try to get away with a gasket that is undersize. Either boil it, or get
a better one.
--
*******************************
Jim Adney, jadney at vwtype3.org
Madison, Wisconsin, USA
*******************************
More information about the type3-vwtype3.org
mailing list