[T3] Fan Closure
Jim Adney
jadney at vwtype3.org
Mon Aug 20 22:47:00 PDT 2018
On 20 Aug 2018 at 21:35, Jeff C wrote:
> I seem to recall that at the center of the fan there is supposed to be a
> plastic cover to keep stuff from getting to the large fan bolt.
>
> I don't have one anymore that I can find.
I'm sure I have a couple around here somewhere. I also have the
correct air tubes for both sides of your engine. Soren is correct;
those tubes should feed non-heated air forward to the mixer boxes on
either side of the tranny. The port you've connected the copper elbow
to is for preheat air to early carbed engines; that port should
probably be plugged on your engine.
Those bits of corrugated alum foil flex tubes that you've used to
connect the elbows to the heat exchangers won't last long. That's one
of the downsides of the aftermarket exhausts, and the little short
piece that holds the elbow to the fan housing will also disintegrate,
meaning that you'll then lose the elbow, too. If you really want to
try this, use some wire to tie the elbows to the engine, so when they
come loose, they don't fall completely off.
I'll be out of town for the rest of this week, but if you want those
parts, email me and we can take care of it in a few days.
--
*******************************
Jim Adney, jadney at vwtype3.org
Madison, Wisconsin, USA
*******************************
More information about the type3-vwtype3.org
mailing list