[T3] be-brake bracket problem

Jim Adney jadney at vwtype3.org
Fri Jun 29 11:26:33 PDT 2018

On 29 Jun 2018 at 12:54, Bobnotch wrote:

> Yes, that bracket is welded to the tunnel.

> I think welding a washer would be a good easy solution, since the pin is usually rusted to the handle.

> One could even tack weld the pin (put the tack near the top to make it
> easy to get to for pin removal) to the washer, if the pin actually
> slides easily thru the handle. 

I've never come across one that was rusted to the handle, but this is not an 
area that I get to often. I like the idea of tacking the pin in place after welding 
a washer there.

Sounds like some grease there would be a good idea.

Jim Adney, jadney at vwtype3.org
Madison, Wisconsin, USA

More information about the type3-vwtype3.org mailing list