Hey Bob,<br>with the beam metal being 2mm thick, can I weld my retention devise to that metal if I make the runner long enough to spread the load?<br><br><div class="gmail_quote">On Thu, Jan 3, 2013 at 10:50 AM, John Jaranson <span dir="ltr"><<a href="mailto:jaransont3@comcast.net" target="_blank">jaransont3@comcast.net</a>></span> wrote:<br>
<blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><div class="im"><br>
On Jan 3, 2013, at 12:32 PM, Gary Forsmo wrote:<br>
><br>
> It appears that you've cut a small, square access hole in the lower<br>
> portion of the axle beam.<br>
> I assume there is (or will be) another access hole to accommodate the<br>
> "companion" air-ride hardware on the other end of the beam?<br>
> In the picture, are we looking at the right or left end?<br>
<br>
</div>Yes, there will need to be an access hole on both the left and the right side of the beam.  The photo is of the front of the right hand side of the beam.<br>
<div class="im"><br>
><br>
> While you have the beam "open", can you put a micrometer on the<br>
> thickness of the axle beam metal stamping?<br>
><br>
> What is that nominal dimension?<br>
> Or does the dimension vary, depending on where you mic the metal?<br>
> If VW stamped the axle beam, I would suspect there would be some<br>
> "stretching/thinning" of the metal, depending on how much "draw" the<br>
> stamping required.<br>
<br>
<br>
</div>The thickness measures 2.0 mm just about everywhere that I can get a caliper on it.  There are a couple of areas that were 0.1-0.15mm thinner due to the stretching/thinning during the stamping process.<br>
<br>
<br>
Later,<br>
John Jaranson<br>
<a href="http://www.carartbyjohn.com" target="_blank">www.carartbyjohn.com</a><br>
<br>
-------------- next part --------------<br>
An HTML attachment was scrubbed...<br>
URL: <<a href="http://lists.vwtype3.org/pipermail/type3-vwtype3.org/attachments/20130103/b5ffe8d1/attachment.htm" target="_blank">http://lists.vwtype3.org/pipermail/type3-vwtype3.org/attachments/20130103/b5ffe8d1/attachment.htm</a>><br>

<div class="HOEnZb"><div class="h5">_______________________________________________<br>
VWType3.Org mailing list - <a href="mailto:type3@vwtype3.org">type3@vwtype3.org</a><br>
<a href="http://lists.vwtype3.org/listinfo.cgi/type3-vwtype3.org" target="_blank">http://lists.vwtype3.org/listinfo.cgi/type3-vwtype3.org</a><br>
Contact <a href="mailto:gregm@vwtype3.org">gregm@vwtype3.org</a> if you need help with the list.<br>
</div></div></blockquote></div><br><br clear="all"><br>-- <br>Brian Fye<br>Canyonville Christian Academy <br>541 839 4401 ext. 110<br>