<div dir="ltr"><span style="font-family:arial,sans-serif;font-size:13px">all i can tell you is that when i used chris' method the distributor gear slipped right into place with the distributor drive gear at a perfect 60 degree angle. as i mentioned earlier the spot is about 24 degrees to the right of the mark on the pulley but the engine starts right up.? i am still puzzled what i should use as the correct timing for this engine, it has a later pulley but so what?? thanks kk</span><br>
<div><span style="font-family:arial,sans-serif;font-size:13px"><br></span></div><div style><br></div><div style><font face="arial, sans-serif">Hi Ken, what you describe is exactly what I experience every time I have set my valves using this method. The 24 degree difference you describe is typical when using this method. </font></div>
<div style><font face="arial, sans-serif"><br></font></div><div style><font face="arial, sans-serif">An important final step when you are at that point, when you have used the method I described to find TDC for no.1 and see that notch on the pulley is 24 degrees off, is to reach down through the inspection hole and put a spot of White paint or White out at 12 O'clock on the Pulley. That paint spot then becomes your new 'notch' for timing purposes.  From now on you're timing to the Paint Spot rather than the Notch. </font></div>
<div style><font face="arial, sans-serif"><br></font></div><div style><font face="arial, sans-serif">That is all you need to do to then time your motor with a timing gun, if you have a type 3 whose timing is set to Zero Degrees TDC per the manual. If your model is timed to 5 degrees before or after TDC, you can turn the knob on your timing gun to dial the right spot in. </font></div>
<div style><font face="arial, sans-serif"><br></font></div><div style><br></div></div>