<div dir="ltr">I let it cool down for an hour or so and examined the engine. I noticed that the underside of the rubber bellows was detached from the body and curled inwards, allowing exhaust to enter the cooling stream. Fingers crossed thats all it was. I reattached it as best I was able - a combination of a smaller reproduction bellows and old tired clamps make a tough fit. I got it back on and put some white out on the rod and the case near the distributor and warmed the car up, hoping to be able to see the rod eventually turn. I looked at the thermostat with a flashlight and it appeared to have expanded after a couple of test rides and leaving it running, but I didn't see the white out marks move at all so it seemed like the rod didn't turn, although I couldn't be sure. I'm going to try again tomorrow with the trick you mentioned of using a wire through the spark plug clamp hole. <div>
<br></div><div><br></div></div>