<div dir="ltr"><div class="gmail_extra"><div class="gmail_quote">On Sun, Mar 9, 2014 at 5:59 PM, Jim Adney <span dir="ltr"><<a href="mailto:jadney@vwtype3.org" target="_blank">jadney@vwtype3.org</a>></span> wrote:<br>
<blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><div class="">>> Otherwise, check to make sure you have the adjusters retracted all<br>>> the way, the parking brake all the way released, and the pistons<br>

>> fully retracted. You've already made sure the new shoes were not<br>>> installed skewed up or down a bit.<br>
<br>
</div>>And one more thing:<br>
<br>>The slots in the adjusting screws have angled bottoms. They should<br>>face slight upwards, toward the shoes, not downward.<br>
<div class="HOEnZb"><div class="h5"><br></div></div></blockquote><div>Yes to all of the above, except that last point about the slots on the adjusting screws I did not pay any attention to.  But before I read this reply, I nosed around in my garage some more and was surprised to find another spare set of brake shoes.  They were in a plain box I got from Aircooled.net  a long time ago (newspaper packing in the box is dated 2002).  No manufacturer or part number noted anywhere.  The lining on these measured between 4 and 5 mm.  </div>
<div><br></div><div>The other shoes that I could not get to fit measured about 7mm and came in a box that said World Wide Friction(TM).  No part number.  But they did have a sticker that said they came from Autohaus Arizona.  I probably ordered them sometime in the past 5 or 7 years, but forgot I had the other set from Aircooled.net sitting on the shelf.  </div>
<div><br></div><div>After switching the shoes out with the 5-mm thick linings the drums went right back on.  The brakes adjusted with about 7 or 8 clicks of the little brass adjusting stars, which seemed about right to me.  </div>
<div><br></div><div>So in the end I think those shoes with the ticker lining just did not fit right.  But next weekend I think I'll open things back up and have a closer look at the slots in those adjusting screws.  </div>
<div><br></div><div>Over the past few years I have been relying almost exclusively on public transportation and tend to drive my Fastback very little -- usually only on sunny Sundays.  Few driven miles has made me a bit unpracticed in basic maintenance, and I have to pull out the manuals for simple little jobs like brakes.  So I certainly appreciate the good tips from everybody.  Overall it was a good weekend for the Type 3.  New brake shoes, changed brake fluid, oil change, valve adjustments, checked timing and points, and tweeked the idle speed (the only adjustment needed for the FI).  My old diesel Mercedes also finally got some attention.  </div>
<div><br></div><div>Next on my list is a job I have been putting off for over 10 years: the shift rod coupler!  </div><div><br></div><div>Mark</div><div>'69 Fastback</div></div></div></div>