<div dir="ltr">I want to have a discussion about seat bases. As some of you may know, I have a 66 Squareback. I was wondering if there is a difference in seat bases between the different years?<div><br></div><div>I am asking because my seats do not like to lock in place. I don't know if the locking "claws" that steady the tracks are....mates. I am about to install interior carpet, which will mean taking out the seats. Because of their want to either move without warning or not move when you want them to, I want to remedy my seats when putting everything back together..</div><div><br></div><div>The seat release cable, that the door activates, works on both sides of the car. I currently have it connected and functioning on the passenger side. On the driver's side, It does not seem to adjust to a point where it will function.</div><div><br></div><div>What I want to know is, where is this cable supposed to mount onto the seat base? Right now, on the passenger side, I have the little hook held tight by the wing nut on the seat base and the seat release works as it should when the door is open. I cannot use the wing nut on the driver's side seat base because the cable is too long. When the cable is pulled to where it would affect the release hook, I am about 2 inches past the wing nut. I do not have enough adjustment to get it to work.</div><div><br></div><div>These two issues I have with my seat have cause me to think I may not have the correct seat bases for a 66 in my car. I could just be crazy and need some guidance from one of the gentlemen on the board with more experience than I have.  If you would like me to post some pictures, please let me know what pictures would help most and I will go snap them.</div><div><br></div><div>Adam</div></div>