<div dir="ltr">On Wed, Nov 4, 2015 at 7:49 AM, Jim Adney <span dir="ltr"><<a href="mailto:jadney@vwtype3.org" target="_blank">jadney@vwtype3.org</a>></span> wrote:<br><div class="gmail_extra"><div class="gmail_quote"><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">
Once this is done, you can put everything back together, or you can<br>
consider doing one more thing: Remove the #2 P/C and check the bore<br>
for excess wear. The concern here would be that if #2 was not firing<br>
for a long time, while gas was still coming in, the cylinder wall and<br>
the rings might have gotten extremely worn.<br>
<br></blockquote><div><br></div><div>I read in the Muir book (Bentley doesn't speak to this issue) that if one were just servicing the heads then you should be very careful to make sure the cylinders do not pull away from the case when removing the cylinder head.  What is the basis for this statement?  Is it just that it is more a PITA if it slips off?<br><br></div><div>So here is my naive question: If I pull the #2 P/C to check the bore, aside from keeping the internals clean, is there anything else I need to be concerned about when I reinstall the P/C again (whether I reuse or get a new one)?<br> </div><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">
Are these the OG 85.5 mm P/Cs? If so, someone may have a used<br>
replacement that would be better than yours.<br>
</blockquote><div><br></div><div>Yes, they are 85.5.  My engine builder sourced new ones from someplace.<br><br></div><div>Part of me is of the mindset that if I already have the engine out and it will take minimal effort at this point to replace the P/Cs that perhaps that is wise.  It is not like I am using OG P/Cs and I think my builder only charged me ~ $165 for the current set--so they are likely a budget set as-is.<br><br>I will likely do what you suggest, Jim, and start with the #2 P/C and check its bore.  If it shows too much wear, I am inclined to replace all 4.  If I go that route, what kind should I buy for a stock application (forged vs. cast) and new chinese-made vs. old (and probably expensive) german (or maybe brazilian)?<br></div><div> </div></div><br></div></div>