<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN">
<HTML><HEAD>
<META content="text/html; charset=US-ASCII" http-equiv=Content-Type>
<META name=GENERATOR content="MSHTML 11.00.9600.17344"></HEAD>
<BODY id=role_body style="FONT-SIZE: 10pt; FONT-FAMILY: Arial; COLOR: #000000"
bottomMargin=7 leftMargin=7 rightMargin=7 topMargin=7><FONT id=role_document
color=#000000 size=2 face=Arial>
<DIV>In a message dated 11/24/2015 8:47:00 A.M. Eastern Standard Time,
craigslistcsprings@gmail.com writes:</DIV>
<BLOCKQUOTE
style="PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: blue 2px solid"><FONT
style="BACKGROUND-COLOR: transparent" color=#000000 size=2 face=Arial>What
length is the driver's side heat tube that goes from the heater box to<BR>the
inlet into the cab of the car? I have a length of galvanized metal<BR>ducting
that I want to get cut while I am at work today.<BR><BR>Our just give me both
measurements,I may have enough to get both cut. The<BR>tubing collapses just
enough to compress top get into place and then<BR>stretch top fill the
gap.<BR><BR>Adam</FONT></BLOCKQUOTE>
<DIV>The parts book doesn't give a length, only an ID of 65mm. I do know the
left side is longer than the right though (due to cylinder set back).</DIV>
<DIV>Some day when we find out it's correct length, I'll add it to my Bentley. :
)</DIV>
<DIV> </DIV>
<DIV>What I did when I replaced mine, was to fit it in place on the body side,
then mark it with a sharpie (with it stretched out), so I knew where to cut
it. Then I added a tack weld on each end so it wouldn't unravel (why I had
to replace it). Keep in mind that it should collapse about an inch to get onto
the heat exchanger end (then you pull it in place, and add a clamp around the
tabs on the HE's).</DIV>
<DIV>I hope this helps.</DIV>
<DIV> </DIV>
<DIV><FONT lang=0 size=2 face=Arial FAMILY="SANSSERIF" PTSIZE="10">Bob 65 Notch
with sunroof</FONT><FONT lang=0 color=#000000 size=3 face=Arial
FAMILY="SANSSERIF" PTSIZE="12"><BR></FONT></DIV></FONT></BODY></HTML>