<p dir="ltr">I replaced the fuel hose from the right side rail to the cold start valve. Got an r9 fi rated hose had a thicker wall than the good German fi hose. I used the same fi clamps,  even when tight I could still turn the hose on the barbs yet saw no leaks. I used 5/16" Id hose think the German hose was 7.3 mm id. The bolt plug I had in was really tight and difficult to get out. I need to run it and see if the new hose remains leak free . Also pulled the battery to check level been a year it was fine.</p>
<div class="gmail_quote">On Jul 14, 2018 10:57 AM, "William Jahn" <<a href="mailto:willjahn975@gmail.com">willjahn975@gmail.com</a>> wrote:<br type="attribution"><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><div dir="ltr">Since my cold start valve does not leak I'll just get another hose and connect it back up. Since my car was getting such lousy MPG I was told forget by whom to remove the line and plug it . I know some use that line for a gauge connect and I couldn't get at the clamp on the cold start valve so I just cut it which was my mistake. I can't say I trust R7 grade fuel hose in the engine compartment yet I think auto zone has ethanol rated hose. I don't check the fuel pressure at all other than a few times since I got this car and last time was after replacing the fuel pump to a 2 port one. It didn't change and I didn't expect it to, the pump has nothing to do with it directly. <div><br></div><div> Yes I was lucky I was in a parking lot . even then I was not sure right away what the no start issue was until I saw the fuel dripping . Beside that it being so hot and humid here standing out in the blazing sun was no picnic or was the idiot with his 5000 watt car stereo system cranked up to 10 . </div></div><div class="gmail_extra"><br><div class="gmail_quote">On Sat, Jul 14, 2018 at 5:03 AM, Jim Adney <span dir="ltr"><<a href="mailto:jadney@vwtype3.org" target="_blank">jadney@vwtype3.org</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><span>On 13 Jul 2018 at 12:44, William Jahn wrote:<br>
<br>
> Turns out it was a 5/16" 2" long bolt I used to plug the fuel line from<br>
> the line that fed the cold start valve . I long ago cut that line and<br>
> left enough to fit the fuel pressure gauge it's about 1 foot long . I<br>
> have 2 clamps on that line to clamp the bolt/plug FI clamps and found<br>
> the plug on the ground . I did this because I thought perhaps the cold<br>
> start valve might leak ,it didn't . I also use that hose with the plug<br>
> to connect the fuel pressure gauge rather than the port on the left<br>
> rail . <br>
<br>
</span>The best way to disable the cold start valve is to simply disconnect the <br>
electrical plug. I don't recall ever seeing a CSV leaking, but I suppose it <br>
might happen. I don't know of a better way to plug an unused hose, but <br>
leaving the end of the hose free to vibrate around probably made the bolt <br>
more likely to be shaken loose. If you really want to continue doing this, you <br>
should find a way to stabilize the end of the hose.<br>
<br>
You're lucky this happened in the parking lot where it was easy to find the <br>
bolt.  <br>
<br>
I've never found periodical checking of the fuel pressure to be necessary or <br>
useful. Keith is the only one I've ever heard of who has had problems with <br>
his pressure regulator; mine have all been "set and forget" adjustments.<br>
<br>
For Keith, I wonder if an occasional dose of Seafoam gas additive would be <br>
useful. It will clean accumulated gum out of the fuel system. I don't know if <br>
that's been his problem, but maybe so. $10 will buy 2 doses. It's worth a try.<br>
<span class="m_-6841701296393552932HOEnZb"><font color="#888888"><br>
-- <br>
******************************<wbr>*<br>
Jim Adney, <a href="mailto:jadney@vwtype3.org" target="_blank">jadney@vwtype3.org</a><br>
Madison, Wisconsin, USA<br>
******************************<wbr>*<br>
</font></span><div class="m_-6841701296393552932HOEnZb"><div class="m_-6841701296393552932h5"><br>
______________________________<wbr>_________________<br>
VWType3.Org mailing list - <a href="mailto:type3@vwtype3.org" target="_blank">type3@vwtype3.org</a><br>
To unsubscribe or change subscription options, visit:<br>
<a href="http://lists.vwtype3.org/listinfo.cgi/type3-vwtype3.org" rel="noreferrer" target="_blank">http://lists.vwtype3.org/listi<wbr>nfo.cgi/type3-vwtype3.org</a><br>
If you need more help, contact: <a href="mailto:gregm@vwtype3.org" target="_blank">gregm@vwtype3.org</a><br>
</div></div></blockquote></div><br></div>
</blockquote></div>