The original, brown Cargo Mat in the rear of my '69 Square has cracked transversly due to age, sun, and engine heat.  It's now in two, pieces<div><br></div><div>The front ~half of the mat is "captured", just behind the rear seatback, by a metal piece that was OEM installed.  The back ~half of the mat is now just laying over the engine cover.</div><div><br></div><div>1.)  I would like remove the front half from that "crimped-over" metal strip, then</div><div>2.)  Re-attach the 2 pieces together with something strong and flexible. </div><div><br></div><div>My first though is to:</div><div>A.) Lay the two pieces (good side down) on a flat surface (like a 4' X 8' sheet of plywood) &</div><div>B.)  Embed a ~12" X 48" piece of woven roving fiberglass into a ~1/4"  layer of something like liquid Flex Seal.</div><div>C.) Let the Flex Seal cure for several days, then</div><div>D.)  Reinstall the (now) one-piece mat back on to rear deck, without re-"crimping" the front edge.</div><div><br></div><div>Questions:</div><div>1.)  Has anybody removed the mat from the front "crimped" metal piece?</div><div>2.)  How did you do it? (Use a flat pry bar?)</div><div>3.)  Suggestions? Cautions?</div><br><br>-- <br><div dir="ltr"><div><div dir="ltr"><div><div dir="ltr"><div>Gary "Frito" - '69 Squareback, FI, MT, One-owner<br></div><div>Rockport, TX (winter)</div><div>Lake Geneva, WI (summer)</div></div></div></div></div></div><br>