<div dir="ltr"><div> I kept asking myself if I torqued the left runner to head nuts. Today I removed the plug wires to access the 2 screws that hold the tin covers in place to access the 2 nuts. They were not torqued at most 5 ft-lb . When I did the right I did it in two steps 7 ft-lb then 14 ft-lb on the left I had to bend the #3 runner up about 1/8" and somehow forgot to torque them . I've only put 30 miles on the car since so I doubt any dust got under the gaskets I had the area pretty clean all around them right up to the valve covers and everywhere else used scrapers and a shop vac and got the entire area clean even used carb cleaner and compressed air. so there was no dirt anywhere same the the runners. . I did the right said too and found they were a bit less than 14 ft-lb they must change through heat cycles.  <br></div><div><br></div><div> Glad I checked , I was so distracted when doing this job because our last cat 17 1/2  year old was just getting near the end plus I'm old .</div><div><br></div><div>William<br></div></div>