<div dir="ltr"><div>From all the fooling around replacing the points and removing the coil HT wire from the coil the coil wire is carbon fiber and I lose spark if I touch it . I used an old Bosch solid core plug wire I kept from an older set cut it to the proper length stripped the end and used an end from another old solid core Bosch and crimped it on and used an old cold boot I still had saved. <br></div><div><br></div><div> Is there any issue using a solid core coil HT lead? The rotor is 5K ohm and the other plug wires read 1K ohm which is just the plug end resistor. Seems the coil wire reads 6.6K ohm if I test it yet has an open if I stress it just a bit.  <br></div></div>