<div dir="ltr"><div>I  replaced my front heater cables from the heat/defrost lever . I wanted to know if the connectors that you connect the cables together like the ones used for the rear foot wells they hold the two cable ends together and also are an adjustment of the cable length are still available . <br></div><div><br></div><div> Mine seem fine yet I didn't know they were plastic. In case I need them is there something like these that can be used? <br></div><div><br></div><div> It was a tough job replacing these. I used late beetle cables they are about 20" longer . The right one was broken about 16" from the connector under the tin cover on the floor. The old ones had bent over ends I had to bend the new ones over just to get them through the tubes/conduit because they were just cut ends yet I didn't make these bends after , I just fit them in and adjusted and cut the extra length off . I left a bit over an inch out past the connector if I need to make bends or fold them over. I didn't strip them just enough to clamp the two cables to hold. I never really looked at the rear ones don't know if they are also plastic with brass screws and a brass base inside the plastic.</div><div><br></div><div>William<br></div></div>