<div dir="ltr"><div>I found friction washers and I used a late beetle / super beetle cables for the front floor/defrost.</div><div><br></div><div> My question is on the floor/defrost lever there are three holes . the top one was not used and when I removed the lever to replace the cable the middle hole was connected to the rear foot wells and the bottom hole to the front. I wasn't sure so I looked again and the rear cable tubes are higher and the front tubes are lower so it appeared they were correct. I saw one post on Samba where one fellow looked at his 73 fast back and he said there were 2 holes and the lower ones went to the rear cables. <br></div><div><br></div><div> After I replaced the front cables and lubed them I set the left control lever to defrost so the front floor flaps were closed , if I pull the left lever up it opens both rear foot wells and the front floor . I don't see a stop for the front flaps when fully open so I used the defrost and adjusted for fully closed . I have the same issue as before, when I pull the left control lever fully up it does not hit the lever stop , it does when fully down. <br></div><div><br></div><div> I don't think anything has even been done with the heater cables. Do I need to adjust the rears at the connectors so the lever hits the stop when fully up? Does it matter if the lever hits the full up stop? <br></div><div><br></div><div> Nothing in the Bentley explains adjustments.<br></div><div><br></div><div>William<br></div></div>