<div dir="ltr">I took apart my doors to access the window mechanisms to get them to move properly and discovered a few things out of the ordinary.<div>The thick asphaltish material used as sound deadening slumped down and fell completely off of the panel on the left side. The plastic covering appeared to be original. The little clip that the door card fits onto had rusted and fell off. I pop-riveted it back on.</div><div>The right side sound deadening material was completely missing. I was obvious that I had been in the right side before as the plastic was torn and re-glued into position.</div><div>All of the mechanisms work well after being lubricated!</div><div>However what recommendations do folks have to use in place of the original sound deadening material? Lots of glue left on the inside of the door.</div><div>Are the small plastic/rubber pockets that the door clips fit into in the metal door available?</div><div>The vinyl is intact but the door card is warped both sides, so I think I'll make a new backing from masonite.</div><div>The vinyl has obtained some bumps and twists from distortion over time. Has anyone had luck moving the material back to position?</div><div>Thanks! Jeff '67 Sqbk</div></div>