<div dir="ltr"><div>I have an older sears with a 12 gallon tank. The copper pipe from the head to the check valve was leaking and I never noticed this. At some point someone over tightened the compression fitting at the head and collapsed the pipe via the brass ferrule. I replaced the check valve it was shot, tried to clean it yet every few cycles it would leak and trip the circuit breaker. <br></div><div><br></div><div> I got a new pipe and 1/2" compression fittings. The new pipe I got had the 90 degree bend and I don't have sand or a tubing bender. <br></div><div><br></div><div> I fit the new pipe and had to cut it , it was a bit longer. The trouble is for whatever reason the pipe is not perfectly round so on each end the ferrules both have a small gap between the ferrules and pipe it's less than an 1/8 wide and .010" at the center the ferrules fit well into the fittings and check valve and all around the copper tube except that one spot so it leaks a bit only while it's running. I tried pipe tape that helped a bit. It's not as bad as the old pipe . I know how to use a tubing cutter and I removed the inside burrs.</div><div><br></div><div> What can I use to seal the small gap? I thought I could just flow a bit of solder in the gap or perhaps silicone like ultra copper . Something that does not blow out. It works fine and the tank holds pressure now and does not trip the breaker . <br></div><div> I can let it be yet any leak does cause the compressor to run a bit longer and as the pressure goes into the tank even a small leak can draw in moisture or fine dust it creates a small vacuum. <br></div></div>