[T3] clamp nut for front wheel bearing
Jim Adney
jadney at vwtype3.org
Sat Feb 12 23:04:34 PST 2011
On 12 Feb 2011 at 11:02, Bryon Garvin wrote:
> The clamp nut is flat on one side and slightly beveled on the other. Is the
> beveled side supposed to be facing out or in ? Does it matter?
That nut appears to be a forging with a "hub" on one side which has
then been machined flat. The other side is "as forged." The flat side
should go against the bearing thrust washer.
The bearing thrust washer may be slightly tapered in one direction,
but it's machined flat on both sides, so it doesn't matter which side
faces the bearing.
--
*******************************
Jim Adney, jadney at vwtype3.org
Madison, Wisconsin, USA
*******************************
More information about the type3-vwtype3.org
mailing list