[T3] Coil, Calipers, and Front Beam

[Jim Adney]

On 2 Jul 2011 at 22:37, Adriel Rowley wrote:

> What does it mean when the primary resistance same as secondary resistance? 

What numbers did you get?

Most likely it means that you're not taking the reading correctly. 
Which terminals were you measuring between in each case? If one 
terminal in each case was the HV terminal, equal readings are what 
you'd expect, and they'd be thousands of ohms.

> Was static timing the engine a few days back, and after which it would
> not start.  So, reset timing again; same results. 

Going from an engine that runs to an engine that won't even start, Is 
not likely to have anything to do with small changes in timing or 
valve adjustment. It's more likely that you bumped something, so that 
you're no longer getting either spark or fuel.

-- 
*******************************
Jim Adney, jadney at vwtype3.org
Madison, Wisconsin, USA
*******************************