[T3] Thermostat spring
Jim Adney
jadney at vwtype3.org
Tue Jul 26 21:21:22 PDT 2011
On 25 Jul 2011 at 22:24, Joe Plowick III wrote:
> Well I found a spring that would work at my local Advance Auto store. I'm
> in the process of getting everything setup and adjusted and noticed one
> small issue. The top of the thermostat rubs against the mounting bracket.
> The mechanism appears to work correctly and opens all the way, but I would
> hate for this to be a place to bind in the future. How would I go about
> adjusting this? I don't see anything that appears to be bent, but I guess
> the thermostat mount could be. This is also an aftermarket thermostat that
> I had from many years ago and still works fine.
>
> Here is a link to a picture of where it binds:
>
> https://picasaweb.google.com/lh/photo/qHduSdGTTREx01tNobvo6Q?feat=directlink
I can't really see what's rubbing, but this photo looks pretty
normal. If it's rubbing against the side of the cylinder that sticks
out the top of the thermostat, you may be able to correct it by
loosening the nut that attaches the bracket to the case and rotating
it slightly.
If you're concerned that the thermostat runs into the top of the
bracket when warm, that's completely normal.
It does appear that the top of the thermostat isn't parallel to the
bottom in your photo. That might be due to the vertical pushrod being
bent. It's supposed to have a couple bends in it, but the top and
bottom sections should be parallel.
--
*******************************
Jim Adney, jadney at vwtype3.org
Madison, Wisconsin, USA
*******************************
More information about the type3-vwtype3.org
mailing list