[T3] Lack of high beam and turn signals

[Adriel Rowley]

Fuse box is only tucked as the scews are missing and have not found the proper ones.

Emergency switch is out of the dash for all the testing and leaving it out until I get it all straitened out.  The insulation moves about quarter half a millimeter.

All mounting screws tight.


Thank you,
Adriel 

> From: jadney at vwtype3.org
> To: type3 at vwtype3.org
> Date: Fri, 13 May 2011 19:38:31 -0500
> Subject: Re: [T3] Lack of high beam and turn signals
> 
> On 13 May 2011 at 8:52, Adriel Rowley wrote:
> 
> > I did get a lot of discoloration out of the switch, but still no high
> > beams or proper turn signals.  I did try disconnecting the turn signal
> > switch but did not have an affect. 
> 
> Undo the 2 screws that secure the fuse box, then carefully pull it 
> down and rearward. Reach up behind the dash and feel the hazard 
> switch. It has a metal box with an insulating panel on one side. That 
> panel is where all the terminals are. Check to see if that panel is 
> loose. It's normally crimped in place, but sometimes the crimps come 
> loose and that panel can get loose or come completely free.
> 
> Be careful when you do this, as there is 12 V to that panel all the 
> time.
> 
> I don't think your problem has anything to do with the TS switch, but 
> you could take the steering wheel off and make sure the 4 screws that 
> hold it in place are still tight.
> 
> -- 
> *******************************
> Jim Adney, jadney at vwtype3.org
> Madison, Wisconsin, USA
> *******************************
> 
> _______________________________________________
> VWType3.Org mailing list - type3 at vwtype3.org
> http://lists.vwtype3.org/listinfo.cgi/type3-vwtype3.org
> Contact gregm at vwtype3.org if you need help with the list.
 		 	   		  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.vwtype3.org/private.cgi/type3-vwtype3.org/attachments/20110513/e29a6d37/attachment.htm>