[T3] Camber Problems
Jim Adney
jadney at vwtype3.org
Sun Sep 11 12:58:34 PDT 2011
On 11 Sep 2011 at 9:46, Brent Bottolfson wrote:
> I can spin the upper ball joint on the right side all the way around and
> it doesn't really change the camber at all. The left side is at about 1*
> positive but the right won't change from about 2.5* positive no matter
> what I do.
This is hard to believe. The ball joint stem should be off center so
that you can see the body of the joint moving around as you turn the
stem. If it really doesn't move, then it must mean that the ball
joint is made wrong and doesn't have any offset machined into the
stem.
The other possibility is that the instrument you're using to measure
the angle max's out at 2.5 deg and you're varying in a range that's
somewhere above that. You could check that by rotating the bottom
ball joint stem and see if that also produces no change.
--
*******************************
Jim Adney, jadney at vwtype3.org
Madison, Wisconsin, USA
*******************************
More information about the type3-vwtype3.org
mailing list