[T3] Wiring for brake switch
Roy Pitchlynn
haterracing at gmail.com
Fri May 4 19:20:44 PDT 2012
Never mind. I am an idiot. We have two wires and the old switch had two prongs. Been a while since I had my head under there.
Roy
On May 4, 2012, at 5:31 PM, Roy Pitchlynn <haterracing at gmail.com> wrote:
> Changing from single circuit to dual circuit master cylinder. The car, 1964 Squareback, had a single prong brake switch, thus only one wire. We picked up a new switch today and the choice was 2 prong or 3 prong, but not single prong. So my question is, do we need a single prong switch or do we need to add a wire and where does that wire tie into?
>
>
> Thanks in advance.
>
> Roy
More information about the type3-vwtype3.org
mailing list