[T3] Front beam is loose
Bobsnotch at aol.com
Bobsnotch at aol.com
Sat Nov 10 03:23:16 PST 2012
In a message dated 11/9/2012 5:55:20 P.M. Eastern Standard Time,
dave at hallvw.clara.co.uk writes:
You're likely to wear the outer part of the tread on the 'new' fronts.
You
need to find out why they are wearing like that. It's usually too much
toe-in, but I suppose if the ball-joints have been replaced, they may not
have set the camber right. I'm not sure how that shows up in tyre wear,
though.
I suggest you get the toe-in checked at least, but see if you can sort the
slack in the sway-bar first in case that changes anything in the
alignment.
You shouldn't have significant slack in the sway-bar adjustment, so I
reckon
you need to look at what's happening there. Presumably you have slackened
off the locknut on the socket-head screw and seen if it tightens more. If
not, try that - it may seat the point of the screw more firmly - and
re-tighten the lock-nut. If it doesn't make any difference, you're
committed to removing the bar and seeing if you can improve the dimple,
which has probably elongated.
I have to agree with Dave on this. But it does show that the uneven wear on
your old fronts was causing some of the vibration / shimmy.
Yes, see IF you can sort out the slack in the sway bar first, then have an
alignment done, as I think it might change the setting a little, and on our
cars, a little can be the difference between just right, and wearing the
tires.
Bob 65 Notch S with sunroof and IRS (Krusty)
64 T-34 Ghia (Wolfie)
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.vwtype3.org/private.cgi/type3-vwtype3.org/attachments/20121110/6d91ac3d/attachment.htm>
More information about the type3-vwtype3.org
mailing list