John L. Morgan IV
emailjohnmorgan at gmail.com
Thu Oct 17 09:01:00 PDT 2013
Am I better served in using the existing cable and handle assembly, which
works fine...or the new cable and handle assembly? I dont have a box at
all, and I hate to go and drill out the one I just got. Is removing the old
one an easy task?
On Thu, Oct 17, 2013 at 11:42 AM, <Bobsnotch at aol.com> wrote:
> In a message dated 10/17/2013 10:31:52 A.M. Eastern Daylight Time,
> emailjohnmorgan at gmail.com writes:
> I got a new one.
> What is the best way to insert it?
> My current cable and pull to open
> the trunk work fine.
> I see that there are rivets that attach
> the new cable and pull to the cardboard.
> What is the best order of operations
> to do this without messing anything up?
> Are you going to re-use your existing cable and handle assembly? If so,
> you'll have to drill out the rivets, and attach them to the new glove box.
> Just so you know, there's a band underneath the box, held by 1 screw (it
> holds the glove box in place). Remove it, and the band, along with a screw
> (or 2 I think) on the inside of the old GB (it goes thru the box/latch
> sideways into a support on the dash), then remove the box from the back
> side of
> the dash. The new one will go in the same way, but in a reverse order.
> Bob 65 Notch S w/Sunroof and IRS aka Krusty
> 64 T-34 Ghia aka Wolfie
> 71 Square-vert under construction
> -------------- next part --------------
> An HTML attachment was scrubbed...
> URL: <
> VWType3.Org mailing list - type3 at vwtype3.org
> Contact gregm at vwtype3.org if you need help with the list.
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the type3-vwtype3.org