[T3] Noise from front end/wheel

Jacob Adam Schroeder jacob.schroeder at gmail.com
Fri Sep 20 22:31:10 PDT 2013


Also, it appears that (worse case) the rebuild kit is readily available
which comes with the bolts and locking plate for one side.  Using the VW
part number (411-698-471), it appears this part may have been shared with
some Porsche's as well.


On Fri, Sep 20, 2013 at 10:20 PM, Jacob Adam Schroeder <
jacob.schroeder at gmail.com> wrote:

> Thank you, that is helpful.  I still have the locking plates on both sides.
>
> What is the purpose of the locking plates?  Perhaps mine are not working
> if they are intended to prevent what happened to me today.
>
>
> On Fri, Sep 20, 2013 at 8:52 PM, <Bobsnotch at aol.com> wrote:
>
>> In a message dated 9/20/2013 11:13:52 P.M. Eastern Daylight Time,
>> jacob.schroeder at gmail.com writes:
>>
>> I jacked up my car, spun the driver's side wheel, and found that  one of
>> the
>> bolts holding my front driver's side caliper to the car had come  off.
>> Thus, the clanging sound I heard was the caliper wobbling  around.
>>  Because
>> the noise started on the highway, there is no way  I'll be able to find
>> that
>> bolt again -- and I don't feel bad for not  searching I-280 before I drove
>> off.  So I'm down one of  these.
>>
>> I plan to zip over to Bugformance tomorrow to see if they have  a
>> replacement for me.  Are these the same as on the bug?  If I  cannot
>> locate
>> one locally tomorrow, does anybody here have a replacement  they'd be
>> willing to sell me?  Also, because I plan to hit all of  these with a
>> torque
>> wrench, what should these be torqued  to?
>>
>>
>> You  might try KGPR (Karmann Ghia Parts and Restorations), or their siste
>> company  Air Head Parts, as the KG uses similar calipers to a type 3.
>> Bugformance might  have 1, but they might have to break into a kit to get
>> you one.
>> You're also  going to need the locking plate for the caliper bolts. The
>> torque for those  bolts is 29 Ft lbs. It's an M10 bolt (no length given)
>> The
>> locking plate is  just barely shown in Bentley, on page 18 of Brakes and
>> Wheels, in figure 7-16,  and on page 22, figure 7-27, part number 14 in
>> the
>> picture. I hope this helps.
>>
>>
>> Bob 65  Notch S w/Sunroof and IRS aka Krusty
>> 64 T-34 Ghia aka Wolfie
>> 71  Square-vert under  construction
>>
>>
>> -------------- next part --------------
>> An HTML attachment was scrubbed...
>> URL: <
>> http://lists.vwtype3.org/pipermail/type3-vwtype3.org/attachments/20130920/33b0140a/attachment.htm
>> >
>> _______________________________________________
>> VWType3.Org mailing list - type3 at vwtype3.org
>> http://lists.vwtype3.org/listinfo.cgi/type3-vwtype3.org
>> Contact gregm at vwtype3.org if you need help with the list.
>>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.vwtype3.org/pipermail/type3-vwtype3.org/attachments/20130920/a23ba865/attachment.htm>



More information about the type3-vwtype3.org mailing list