[T3] floor pans

[Bobsnotch at aol.com]

In a message dated 10/14/2014 10:53:19 A.M. Pacific Daylight Time,  
alluringeyewear at comcast.net writes:

Hello  all!  I am just starting to repair my floor pans.  The front  
sections look good and are very solid the backs need replacing.  Are  there any 
other VW pans that would work or do I have do look for type 3  pans?  I would 
change the drivers front section if it were inexpensive,  if not I can weld 
the few small holes.  
 
Most people are using Gerson full length pan halfs, or ISP pan sections. If 
 you're up for a challenge, you can use T-1 Ghia floor pans, but they're 
not a  direct replacement. My understanding is that you'll need to re-use the 
outer lip  (bolt section) from your old T-3 pans, and trim off that area 
from the Ghia  pans.
I hope this helps.  

Bob 65 Notch  with Sunroof
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.vwtype3.org/pipermail/type3-vwtype3.org/attachments/20141014/65edab7a/attachment.htm>