[T3] Tooling for Rebuilding Type 3 Parts

William J catnine09 at dslextreme.com
Wed Jan 3 12:06:15 PST 2018

 I looked at the tools . I can see how some work.
Why leave out the 10 LB hammer needed to drive the dist dog pin out.

 Nice tools you must have a lathe and good drill press .
----- Original Message ----- 
From: "Jim Adney" <jadney at vwtype3.org>
To: <type3 at vwtype3.org>
Sent: Tuesday, January 02, 2018 8:32 AM
Subject: Re: [T3] Tooling for Rebuilding Type 3 Parts

> On 1 Jan 2018 at 22:13, rdavid at rochester.rr.com wrote:
>> A little "behind the scenes" peek into the craftsman's toolbox. Very cool
>> tools, Jim!
> I was hoping some of you would enjoy it. Have you tried figuring out what
> each tool does? Most of them are pretty specific, and one tool in the fuel
> pump tools photo is actually for L-jetronic (Type 1 FI) pumps.
> I actually had to take the distributor tools photo 4 times, because I kept
> forgetting something. I suspect the photos are still not complete, and 
> none of
> them include standard tools, from hammers and punches, screwdrivers and
> wrenches, and hones and whet stones.
> -- 
> *******************************
> Jim Adney, jadney at vwtype3.org
> Madison, Wisconsin, USA
> *******************************
> _______________________________________________
> VWType3.Org mailing list - type3 at vwtype3.org
> To unsubscribe or change subscription options, visit:
> http://lists.vwtype3.org/listinfo.cgi/type3-vwtype3.org
> If you need more help, contact: gregm at vwtype3.org

This email has been checked for viruses by Avast antivirus software.

More information about the type3-vwtype3.org mailing list