[T3] Fuel Pump Circuit
Jim Adney
jadney at vwtype3.org
Mon Apr 22 04:28:41 PDT 2019
On 22 Apr 2019 at 1:23, Dennis Stiefel wrote:
> The trans we just took out had a noise like an input shaft bushing was bad
> despite the low mileage (77k). The only time the noise would stop was when
> the clutch was disengaged.
IIRC, there's no input bushing on that shaft. The only bearings are some
needle bearings between the shaft and some of the gears, and a ball
bearing at the far end. Getting to any of them is a big project. It could also be
needle bearings on the other shaft, which are even harder to get to.
OTOH, if you decide to dive into this, I made some tools quite a few years
ago that would help get those apart and back together again.
Are you getting the 2 relay clicks when you turn the key ON?
--
*******************************
Jim Adney, jadney at vwtype3.org
Madison, Wisconsin, USA
*******************************
More information about the type3-vwtype3.org
mailing list