[T3] Inner lower bushing dimensions?
Jim Adney
jadney at vwtype3.org
Wed Sep 2 06:46:02 PDT 2020
On 1 Sep 2020 at 13:50, Max Welton wrote:
> Randy Bowen comes through again
>
> https://www.thesamba.com/vw/gallery/pix/2084132.jpg
Is that a new installed bushing? Looks awfully clean in there; you can even
see the hole where the Zerk feeds in.
> Cleaned up my trailing links too
>
> https://www.thesamba.com/vw/gallery/pix/2084131.jpg
Beautiful. So many of those show bad wear by now. The small diameter part
looks longer than normal. Did you have to turn that down to a smaller
diameter to clean it up? If so, that would be the advantage to making your
own bushings. It would also take a pretty large lathe and some clever
fixturing to center it and then clear the trailing arm.
--
*******************************
Jim Adney, jadney at vwtype3.org
Madison, Wisconsin, USA
*******************************
More information about the type3-vwtype3.org
mailing list