[T3] Clementine going crazy.

[Dennis Stiefel]

Sent from my iPhone

> On Jan 5, 2022, at 7:22 AM, Jim Adney <jadney at vwtype3.org> wrote:
> 
> On 4 Jan 2022 at 22:42, Dennis Stiefel wrote:
> 
>> The primer switch I installed right after I got it from you when you were
>> down here during the invasion in 2018. It has worked with no issues till now.
>> Still works. I can double check my work installing that but odd it waits this
>> long before giving issues. 
> 
> That toggle switch has 3 positions: OFF/NORMAL/(PRIME). The (PRIME) 
> position should be momentary. Any chance there's something wrong with the 
> switch that has allowed it to stick in the momentary position?
> 
> No matter what is happening elsewhere, if that switch is in the OFF position 
> (away from you) the pump should not run at all. If it does, there's something 
> wrong with either the switch itself or its installation.
> 
> -- 
> *******************************
> Jim Adney, jadney at vwtype3.org
> Madison, Wisconsin, USA
> *******************************
> 
> __________________________________________

I checked it this morning and got to wiggling wires in the area I worked at. There is a 4 way junction where 4 wires connect close to the MAP sensor above the injectors for 3 and 4.  When I wiggled that a wire popped out like it wasn’t in good. I’m thinking I must of almost pulled it loose and it was still getting a half way connection because when I got it plugged it properly it solved all the issues I was having.  Started running right like before and the fuel pump started cycling on and off like it should with the ignition switch.  Thanks for the help!
Dennis