[T3] Push-rod length...

[David Hall]

FYI My two spares both measure 153mm - tip to centre of hole, for '70s dual
circuit, so yours probably should be similar if it's a long-nose Type 3
(70-on).  I've not had a short nose dual circuit, but I suppose that might
be different.

Dave.
UK VW Type3&4 Club.
========

-----Original Message-----
From: type3-bounces at lists.berkeley.edu
[mailto:type3-bounces at lists.berkeley.edu] On Behalf Of Frank Meek
Sent: 29 December 2010 18:43
To: type3 at lists.berkeley.edu
Subject: [T3] Push-rod length...

Hi there
Sometime back there was a discussion of brake push-rods and their factory
length, which is inexplicably absent from the "factory" Bentley manual.  I
don't recall whether it was Jim or Russ, but if that metric number is
available, I would like to add it to my "factory" manual.  Thanks.
Best regards
FE Meek
-------------- next part --------------
An HTML attachment scrubbed and removed.
HTML attachments are only available in MIME digests.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Unsubscribe?  See http://www.vwtype3.org/list/ Need list help?
mailto:gregm at vwtype3.org
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~