[T3] rear axle nut
Jim Adney
jadney at vwtype3.org
Thu Aug 11 05:44:10 PDT 2011
On 10 Aug 2011 at 18:40, crash 69 wrote:
> 1.14 x 12" = 13.7, or about 14" out. Makes sense? I presume "no bouncing",
> because that would add torque.
Exactly right. Measure from the drive center outward, then wrap a bit
of tape around that spot so you know where to put your foot. Apply
your weight with the bar horizontal.
Once you're there, check the alignment of the holes and then tighten
more if necessary to align one set of holes. Use a standard cotter
pin.
--
*******************************
Jim Adney, jadney at vwtype3.org
Madison, Wisconsin, USA
*******************************
More information about the type3-vwtype3.org
mailing list