[T3] CV concave washer
Jim Adney
jadney at vwtype3.org
Thu Sep 1 06:15:47 PDT 2011
On 1 Sep 2011 at 11:04, Dave Hall wrote:
> If the slots the balls run in aren't right, the joint is rigid - won't angle
> at all!
Yeah, I did that once by accident. I discovered the mistake as soon
as it was assembled, but the real surprise was how hard it was to
take apart again.
> Those photos seem to show quite worn places where the balls have sat in the
> cage. Is that normal? I guess if the surfaces the balls run on are
> reasonably smooth, I guess it's not a problem. Maybe the wear area is only
> polishing.
This is normal. A bad cage is obvious: it comes out in pieces!
--
*******************************
Jim Adney, jadney at vwtype3.org
Madison, Wisconsin, USA
*******************************
More information about the type3-vwtype3.org
mailing list