[T3] CV concave washer
Jim Adney
jadney at vwtype3.org
Thu Sep 1 18:48:33 PDT 2011
On 1 Sep 2011 at 18:41, Bryon Garvin wrote:
> > If you're asking about axial motion (not flex) then I would expect it
> > to move equally in both directions. Either way, it should move until
> > the center race comes to rest against the ball retainer.
> Well, I thought the same. There's no grease in there yet, so maybe it
> doesn't want to travel there easily. However, it's reassembled EXACTLY as
> taken apart except that the inner race appears to be 120 degrees opposed to
> its original position (I made a mark aligning the two, but in reassembly I
> botched it). But the races are facing the right way, the balls are from
> that same joint. The only thing I might have messed up is turning the cage
> around but I think folks here agreed that shouldn't matter.
Can you see that the axial motion is being stopped by the center race
running against the ball retainer?
> If I assembled it incorrectly, it wouldn't move at all, right?
That's what I would expect.
--
*******************************
Jim Adney, jadney at vwtype3.org
Madison, Wisconsin, USA
*******************************
More information about the type3-vwtype3.org
mailing list