[T3] Parting out front axle and rear subframe!
Bobsnotch at aol.com
Bobsnotch at aol.com
Sat Sep 17 10:27:21 PDT 2011
In a message dated 9/17/2011 12:59:34 P.M. Eastern Daylight Time,
jadney at vwtype3.org writes:
The caps wrap about halfway around the torsion tubes and are located
on the forward face of the torsion tubes, just outboard of the center
forging that has the torsion bar splines and that the tranny attaches
to. You can easily see at least part of them from below.
Jim, would this area be covered by the boxed reinforcement on the earlier
subframes? I'm just asking, because VW did away with the boxed sections in
mid 69 (to allow more cooling air for the AT, at least that's VW's reason).
If so, then that vent/drain would be covered.
Bob 65 Notch S with sunroof and IRS (Krusty)
71 Notch (Krunchy)
64 T-34 Ghia (Wolfie)
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.vwtype3.org/private.cgi/type3-vwtype3.org/attachments/20110917/53681e4e/attachment.htm>
More information about the type3-vwtype3.org
mailing list