[T3] Plug wire advice
James Lingenfelter
jimmyandcher at yahoo.com
Sat Jun 16 20:31:03 PDT 2012
Thanks for the link; I guess I will contact them and see if there is
a way I could get a set that's a couple of inches longer than what I
have.
Jimmy
On Jun 16, 2012, at 5:20 PM, Mike Fisher wrote:
> I made a Bosch set fit, but they really are too short! I saw these
> recommended on the Samba, but I haven't used them myself.
>
> http://auroraignitionwires.com/
>
>
> On Sat, Jun 16, 2012 at 6:53 PM, James Lingenfelter
> <jimmyandcher at yahoo.com>wrote:
>
>> Hi guys; I have a dead plug wire to cylinder #1, and would like to
>> know
>> what plug wire set you guys recommend. The reasons that the plug
>> wire is
>> bad are: 1. The wires exit vertically out of the boots at the
>> distributor
>> end, and there is no clearance between the top of the distributor
>> -especially where #1 wire comes out- and the engine hatch, so the
>> plug wire
>> is nearly crimped at a right angle where it exits the boot, and 2.
>> The plug
>> wire to cylinder #1 is really too short, so it is stretched to the
>> max just
>> to barely reach, putting stress on the wire connections at both
>> ends. So,
>> the connection at the distributor end is shot, and #1 cylinder is now
>> intermittent.
>> My dilemma is this: this is about the 3rd plug wire set I have
>> tried...
>> the first two were higher quality (I think at least one was a
>> Bosch set),
>> and had the right angle boots at the distributor end.... BUT, in
>> both of
>> those cases, NONE of the wires were long enough to reach cylinder
>> #1....
>> not even close, even though I bought all of these sets at the
>> local VW
>> parts store, whose computer insisted the sets were for a type III. I
>> finally went with this cheap, lower quality Empi set, simply
>> because with
>> some slight stretching, and creative routing THROUGH the carb
>> linkage, I
>> could actually get #1 wire to reach.
>> Is there some secret part # that you guys could give me? My dream
>> plug
>> wire set with right angle boots AND enough length to reach the plugs?
>> Thanks,
>> Jimmy
>>
>>
>>
>> ______________________________**_________________
>> VWType3.Org mailing list - type3 at vwtype3.org
>> http://lists.vwtype3.org/**listinfo.cgi/type3-vwtype3.org<http://
>> lists.vwtype3.org/listinfo.cgi/type3-vwtype3.org>
>> Contact gregm at vwtype3.org if you need help with the list.
>>
>
>
>
> --
> Eugene, Oregon
>
> http://s169.photobucket.com/albums/u236/mr_bojangles500/
> -------------- next part --------------
> An HTML attachment was scrubbed...
> URL: <http://lists.vwtype3.org/private.cgi/type3-vwtype3.org/
> attachments/20120616/faa78144/attachment.htm>
> _______________________________________________
> VWType3.Org mailing list - type3 at vwtype3.org
> http://lists.vwtype3.org/listinfo.cgi/type3-vwtype3.org
> Contact gregm at vwtype3.org if you need help with the list.
More information about the type3-vwtype3.org
mailing list