[T3] CV joints on a 68 swing axle

[Bobsnotch at aol.com]

In a message dated 4/4/2013 1:23:03 P.M. Eastern Daylight Time,  
rcrogers1 at peoplepc.com writes:
 
Also many of us have a tool that can remove the nut.  The tool  fits over 
the nut much like a socket and a hammer is used to turn the  tool. 
 
 
 
I have a 36mm socket welded to a piece of flat bar stock that's 3 foot  
long. I just stand on the end of it, and bounce a couple of times to  either 
break the nut loose, or tighten it. It's a left over  tool from my beetle 
days. ;-)  

Bob 65  Notch S w/Sunroof and IRS aka Krusty
64 T-34 Ghia aka Wolfie
71  Square-vert under  construction


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.vwtype3.org/pipermail/type3-vwtype3.org/attachments/20130405/663af7cf/attachment.htm>