[T3] 73 T3 IRS rear bearings?
Jim Adney
jadney at VWType3.org
Mon Feb 8 18:06:29 PST 2016
On 8 Feb 2016 at 14:22, William J wrote:
> I keep reading most say this nut requires a 3/4" drive no pivot breaker
> bar. I only have a 1/2" drive pivot type.
In an emergency, you can mimic the 215 lb-ft of torque with a large
pipe wrench. Just take your weight and divide it into 215. The answer
is the number of feet out from the axle center that you have to stand
on the wrench (no bouncing) to give you the right torque.
Do this with the wheel and tire on the ground, then do whatever
torque you need, to advance the special nut to the next cotter pin
hole.
--
*******************************
Jim Adney, jadney at vwtype3.org
Madison, Wisconsin, USA
*******************************
More information about the type3-vwtype3.org
mailing list