[T3] Bad day at the (FI) office
Jim Adney
jadney at VWType3.org
Tue Mar 15 15:00:30 PDT 2016
Okay, Daniel, 2 more brains are on their way to you. One is an A
brain, rebuilt by Bosch into a CU10X, which I assume means it was
rebuilt into a B. The other one is a B. Both were tested by me, but
only to the same degree as the one you already got from me.
The Post Office expects to deliver on Thursday.
Packed in between the 2 brains is a piece out of the edge connector
of another B brain, in a tiny zip lock bag. Use it to like a feeler
gauge to check each pin in the brain connector on your harness. Pay
special attention to these pins:
16 is the 12 V power input for the logic
11 is the logic ground
24 is the 12 V input for the injectors
3, 4, 5, & 6 are the outputs to the injectors
The connectors that carry the highest currents need to be the
tightest. Those would be 3, 4, 5, 6, & 24.
If you find any of these to be loose, you can carefully bend the
connector pin with a small tool, to tighten it up slightly. Be
careful, don't overdo it.
--
*******************************
Jim Adney, jadney at vwtype3.org
Madison, Wisconsin, USA
*******************************
More information about the type3-vwtype3.org
mailing list